The smaller detail pieces were glued with craft glue to the main body of the blade. So I made a second copy of the sword using a thicker piece of cardboard and with the cardboard 'grain' following the long direction of the sword, but slightly off (about 30 degrees) so it had strength in both directions.

This resulted in the sword being weak length-wise and prone to flexing and bending. My initial cardboard draft I cut was out the the 'grain' of the cardboard perpendicular to the long axis of the sword.

There are some pretty small details, especially the center channel of the sword that required patience. The metal rod is 10mm in diameter and 80cm long. It's 1 meter long and its designed to be mounted on a metal rod from the hilt to the tip for structural strength.

These couple of pieces needed to have two copies made (one of each for each side of the sword.)Īll pieces of cardboard were cut out using an Xacto blade. 1 download 3D model description This is my 3D model of Gamora's Godslayer sword from Guardians of the Galaxy. There are also a couple of other smaller pieces that are hear the handle of the sword where the sword is thicker and has some detail and design. I found some artwork and printed it on a transparency film, then projected it on the wall where I had taped a piece of cardboard and traced the image onto the cardboard after I had adjusted the image to the desired size - about 2'. and it will harden very fast.īondo spot putty is great to put in the seams where the parts were glued together.Her sword has a very unique shape to it. 3 is set to introduce the incredibly powerful Adam Warlock to the Marvel Cinematic Universe. I found some artwork and printed it on a transparency film, then projected it on the wall where I had taped a piece of cardboard and traced the image onto the cardboard after I had adjusted the image to the desired size - about 2'. By Zachary Guida Published Gamora's sword is known as the Godslayer for several reasons, with it having ties to both Adam Warlock and his evil counterpart. Be careful it is the best superglue you will ever use. Step 1: Create the Basic Shape Her sword has a very unique shape to it. continue this until you are happy with the finishĪlso you can use any spray paint or acrylic paints to paint your item.ģ/16 dowel rod is needed to reinforce the sword.ĬA glue is amazing to glue the pieces together. Parts will require sanding- I start with 120 then prim with a rustolium filler primer from home depot. The Godslayer is a collapsible sword that was used by Gamora which includes a detachable knife that connects to the swords hilt. (Make sure there is no paint on the glued parts or else it will not adhere correctly.

Super glue can be used to combine the pieces. the dowel rods are also not included but can be found at any hardware store. They will come separated so you can easily paint and glue them together to your liking. This listing is for a full set of raw unpainted prints. This listing is for the Gamora's sword Godslayer !! This is my personal design.

Gamora sword godslayer pepakura pattern